b4a-bridge can connect to design but not run

Erel

B4X founder

Staff member

Licensed User

Longtime User

• May 7, 2012

• #2

Do the logs work properly (in the logs tab)?

If yes, then check if there is any error message there when you try to install.

 

Upvote 0

dunski

Member

Licensed User

Longtime User

• May 7, 2012

• #3

It just says
LogCat connected to: B4A-Bridge: HTC HTC Wildfire S A510e-358225042677576

but still nothing happens.
It says connected down the bottom left of the basic4android code ide, it says its connected in the designer. And the designer loads on the phone.
I run it and it goes through the whole compiling without any errors.
But nothing happens on the phone except it just stays in designer mode.

 

Upvote 0

Erel

B4X founder

Staff member

Licensed User

Longtime User

• May 8, 2012

• #4

Are you using Bluetooth or wireless mode?

Seems like it fails to copy the file for some reason.

 

Upvote 0

A

Andras

Active Member

Licensed User

Longtime User

• May 8, 2012

• #5

I have the same device and no problems so far (well, not this one!)

Can I suggest you find an app that will let you explore just what has been loaded onto the phone and go from there; I use ES File Explorer (free!), but there are plenty of others out there.

(I presume everything runs ok on the emulator?)

John

 

Upvote 0

dunski

Member

Licensed User

Longtime User

• May 9, 2012

• #6

@Erel
Yes its just not copying.
I'm using wireless.
Maybe I'll try it on bluetooth. I'll let you know how I get on.
Thanks

@Andras
Thanks for the app suggestion, I loaded it and could find nothing. It works fine in the Emulator.

 

Upvote 0

dunski

Member

Licensed User

Longtime User

• May 9, 2012

• #7

Hey It works on Bluetooth!

Happy Days!!

Thanks Erel

 

Upvote 0

vb1992

Well-Known Member

Licensed User

Longtime User

• May 9, 2012

• #8

I am kinda of curious to why this happens?
It has happen to me a lot with wireless,
and I have to go into the menu

TOOLS / B4aBRIDGE / DISCONNECT

then

reconnect

It just baffles me why I need to be doing this all the time?

 

Upvote 0

Erel

B4X founder

Staff member

Licensed User

Longtime User

• May 9, 2012

• #9

If there is no error message in the logs, it is hard to say why it happens.
It maybe related to the network configuration.

 

Upvote 0

vb1992

Well-Known Member

Licensed User

Longtime User

• May 9, 2012

• #10

I was conscious today of what I was doing,
and I noticed that if I am working on two opened
projects in b4a and both are connected then I ran
into problems.

Is that the case?

 

Upvote 0

Erel

B4X founder

Staff member

Licensed User

Longtime User

• May 10, 2012

• #11

You cannot use B4A-Bridge from two IDEs at the same time.

 

Upvote 0