iOS Question CLOSED - Build-Bridge App Stuck - iOS 18.7 b4i-8.90

[Robert Valentino]

I do a build-bridge and get the QR Code select install get a question about "Open in iTunes" I click Open. It says builder1.b4x.com would like to install B4i-Bridge I select Install

And that's it nothing happens after that. I verified that B4i-Bridge is installed but never seem to get to run my app

When I start B4i-Bridge manually the ip address flashes by so quickly but I do believe it is the same which is in my IDE and shows in setting ip address but my app never starts.
If I go to browser and enter the b4i-bridge ip manually it just asks the same question about Open in iTunes

I am using 8.9 of B4i

 

[Robert Valentino]

I hate to update my own post. BUT I have tried everything I can find here on B4i and cannot get my debug app to start.

I changed from wildcard testing to store test and now it works?

 

[mcqueccu]

is this device new device or you have been using it before the upgrade?

If its new device, make sure to edit your provisionprofile to include the new device UDID.
Also do these

New iOS device - This app cannot be installed because integrity could not be verified

I've just wasted a bit more time than expected, installing B4i-Bridge on a new iPhone. A few tips: 1. Enable developer mode: Settings - Privacy & Security - scroll down - Developer Mode 2. Don't forget to add the new device UDID to the list of devices on your Apple account, create a new...

www.b4x.com

 

[Robert Valentino]

No, old device. When I use a wild card provision with build bridge app it doesn't work.

But if I use a normal store test provision and just do a F5 (compile and run) I can debug and work fine.

I'm ok with that. Just trying to update an old app

Thanks, I will change this to Closed

BobVal