converting Arduino sketch to B4X

Built on this project
Here is the code:
Response by PM only please.

int Sensor_pin = 3;
int ledpin = 11;
void setup()
{
pinMode(Sensor_pin, INPUT); // Set the human infraredinterface as the input state
pinMode(ledpin, OUTPUT);
Serial.begin(9600);
Serial.flush();
Serial.println("Ready");
}
void loop()
{
int val = digitalRead(Sensor_pin); // Define parameters to storethe state read by the human infrared senso
if (val == 1) // Buzzer make alarm if someone is detected
{
Serial.println("There is sb moving");
digitalWrite(ledpin, HIGH);
}
else
{
Serial.println("There isn't sb moving");
digitalWrite(ledpin, LOW);
}
delay(100); // Delay 100 milliseconds }[/CODE]

Search for PIR in the forum
e.g.

thetahsk said:

Search for PIR in the forum
e.g.

B4R PIR (Passive Infrared Sensor) Example

Thanks to Erel for this great product !! (again) Here's a PIR example (presence detection) with Arduino and B4R; the PIR sensor is the PIR HC-SR501 Code: #Region Project Attributes #AutoFlushLogs: True #StackBufferSize: 300 #End Region Sub Process_Globals Public Serial1 As...

www.b4x.com

Click to expand...

Thanks thetahsk
In fact I am using the SR505 without problem.. But I want to use a servo motor with it, where there're also so many examples and it's working perfectly if
it's by itself, the thing I am asking for is how can I combine the two.. It's a bird's cage door opener.. if I am close to door (without touching it, the SR505 will pick the IR signal and logs "Detected" At this time I want the servo motor to travel 90 degrees and open the door (a light weight flap).. when I go away and the sensor signal is lost then it will log (Not detected).. At this time I want the servo returns to 0 degree (closes the door), stops the servo and waits for another visit from me. In other words, I want to combine the two Arduino examples and make them one project.
Indeed I will donate for the time if someone managed to do that.