B4R Question How to read voltage using an irfz44 "N" fet

Cesar_Morisco said:

Hello everyone
I had to make some changes to my project to use the TIP122 as a driver for the IRF5305 FET to work correctly and calculate the voltage divider from 0 to 20v
Now everything is working very well
Thank you for your time
I will post the video soon

Click to expand...

Cesar_Morisco said:

Olá a todos
Tive que fazer algumas alterações no meu projeto para usar o TIP122 como driver para que o IRF5305 FET funcionasse corretamente e calculasse o divisor de tensão de 0 a 20v
Agora tudo está funcionando muito bem
Obrigado pelo seu tempo
Vou postar o vídeo em breve

https://youtube.com/shorts/Pi5bUB1cw2I?si=zlaC5Jsr7H-P8zSd

Click to expand...

Cesar_Morisco said:

Another thing is that your connection diagram doesn't work, the lamp doesn't light up, it doesn't have GND.

Click to expand...

thetrueman said:

In this post the diagram of Proteus ISIS has IRF5305 which is connected in wrong direction. Please note that P-Channel FET Source pin connects with +ve supply and Drain pin connects with Load and Load connects to GND. Simply your circuit is theoretically is good but FET's Source and Drain pins should be interchanged. First you do this and then I will fine tune this circuit.

View attachment 163008

Click to expand...

hatzisn said:

Standard operating procedure with amateur circuit designers. I though ADC counted only voltage and thus the R4 was going to the GND through R5. Are you sure you calculated correctly the R1 and there is no minimum voltage in the lamp to light? Also have you connected the ground of the board to the ground of the circuit? Maybe an apropriate resistor between the voltage divider and the ADC pin in my design would do the trick. Through collaboration we advance though. Glad though I gave you the idea to turn on and off the power in the lamp in the PWM rate at the high side even though you used the NPN transistor. Since I am amateur though, I can make out that your design uses the invert of PWM pulse (when high the gate is low and when low the gate is high) so PWM+ would turn into PWM- and the opposite. Am I wrong? Neh, forget it. I just saw you used the P FET.

Click to expand...