IDE just closes

I don't know if this appends to someone else, and I was almost sure it had to do with some error trapping but, every once in a while , in the device, when i hit "run", the IDE just closes...No errors reported...
Then i re.open the IDE, go back to the same project I was on, and re-run it...
most of the times it had to do with some error, especially, null references, but it has happend, without any error involved....HUM....

Some "fatal" errors like stack overflow may cause this behavior.
Do you use very deep recursions (or endless recursions)?

Erel said:

Do you use very deep recursions (or endless recursions)?

Click to expand...

I don't even know what that means...
Is it something like circular references in Excel?
If so, NO, I do not use any...
Another pointer...
it seems to happen more often if I "forget" B4Ppc open, and the screen is set of, by system time-out..
Then when I ake my device again, And try to run the code, it's more likely to "Close"!

I think you had installed the B4P on your flashcard (sdmmc).
And the connection between the flashcard and the device is lost, if you shut down your device.
Don't know what happens then, but I have the same problem like you.

I installed the B4PPc in the device, but save all the source code in the SD...
I've had some SD issues ( disapearing SD), but it was with another O, with this one never had the problem...
But now that you brought it up, i'll try to save my code in the device and see i it closes too....