Android Question [Solved] How to remove the cross and check (Cancel and confirm) symbol in preference dialog ?

[AnandGupta]

In preference dialog, I want to remove the cross and check symbol from text input as it blocks the input text.




How to do it ?

 

[Mahares]

I want to remove the cross and check symbol from text input as it blocks the input text.

Here it is Anand: Those are the Cancel and confirm buttons

[Solved] How to hide "cancel/confirm" buttons in TextItem of the B4XPreferencesDialog?

How I can hide this buttons? Thanks in advance for any tip.

www.b4x.com

 

[AnandGupta]

Here it is Anand: Those are the Cancel and confirm buttons

[Solved] How to hide "cancel/confirm" buttons in TextItem of the B4XPreferencesDialog?

How I can hide this buttons? Thanks in advance for any tip.

www.b4x.com

Thanks. And I was searching "cross and check" in Forum , even through Google (site:b4x.com)

 

[AnandGupta]

Since the solution was prior to "BeforeDialogDisplayed" event, I made the code as below to get the same result,

Private Sub PrefDialog_BeforeDialogDisplayed (Template As Object)
    For i = 0 To prefDialog.PrefItems.Size - 1
        Dim pi As B4XPrefItem = prefDialog.PrefItems.Get(i)
        prefDialog.CustomListView1.AnimationDuration = 0
        If pi.ItemType = prefDialog.TYPE_TEXT Then
            Dim pnl As B4XView = prefDialog.CustomListView1.GetPanel(i)
            Dim ft As B4XFloatTextField = pnl.GetView(0).Tag
            ft.lblClear.Left = -100dip
            ft.lblV.Left = -100dip
        else If pi.ItemType = prefDialog.TYPE_MULTILINETEXT Then
            Dim pnl As B4XView = prefDialog.CustomListView1.GetPanel(i)
            Dim ft As B4XFloatTextField = pnl.GetView(0).Tag
            ft.lblClear.Left = -100dip
            ft.lblV.Left = -100dip
        End If
    Next

End Sub

 

[Mahares]

I made the code as below to get the same result,

Why didn'y lump both text types in one inside the sub like this:

If pi.ItemType = prefDialog.TYPE_TEXT or pi.ItemType = prefDialog.TYPE_MULTILINETEXT Then
           Dim pnl As B4XView = prefDialog.CustomListView1.GetPanel(i)
            Dim ft As B4XFloatTextField = pnl.GetView(0).Tag
            ft.lblClear.Left = -100dip
            ft.lblV.Left = -100dip
end if

 

[AnandGupta]

Why didn'y lump both text types in one inside the sub like this:

If pi.ItemType = prefDialog.TYPE_TEXT or pi.ItemType = prefDialog.TYPE_MULTILINETEXT Then
           Dim pnl As B4XView = prefDialog.CustomListView1.GetPanel(i)
            Dim ft As B4XFloatTextField = pnl.GetView(0).Tag
            ft.lblClear.Left = -100dip
            ft.lblV.Left = -100dip
end if

Well I had doubt that -100dip may not be correct for B4J module where multiline text is a big one. So I left it as a separate case to be corrected if required, if someone uses the code.