Anyone else run into this?
I have a completely blank form. On this form, I create a label at the top; a scrollbar along the right side, and a TabControl which occupies the remainder of the form.
For each object/control, I am first adding it using AddObject, then New, etc.
I create four tab pages. On each page, I create a panel. On each panel, I create a series of labels, and maybe a button or two.
When the form is closed, every control on the form gets disposed of.
No problem so far.
If I try to re-open the form, my TabControl doesn't show. The label shows up, the scrollbar shows up... no errors are reported anywhere. The TabControl just doesn't appear. I know it's there, though - if I MsgBox out the top, left, width, and height of the TabControl, I get the same four values as when it did appear.
Why would dynamic creation of a TabControl work properly only once?
Gary
:sign0085:
I have a completely blank form. On this form, I create a label at the top; a scrollbar along the right side, and a TabControl which occupies the remainder of the form.
For each object/control, I am first adding it using AddObject, then New, etc.
I create four tab pages. On each page, I create a panel. On each panel, I create a series of labels, and maybe a button or two.
When the form is closed, every control on the form gets disposed of.
No problem so far.
If I try to re-open the form, my TabControl doesn't show. The label shows up, the scrollbar shows up... no errors are reported anywhere. The TabControl just doesn't appear. I know it's there, though - if I MsgBox out the top, left, width, and height of the TabControl, I get the same four values as when it did appear.
Why would dynamic creation of a TabControl work properly only once?
Gary
:sign0085:
Last edited:
