B4R Question Arduino 101 BT not discovered.

[Beja]

Hi all,
I am trying the 101 examples and both, the Android app and the Arduino app are installed successful.
After running the Android app, it stuck in the discovery process for a very long time.
Then I went to settings in the Android phone to try to pair from there.. this is the message..
Any clue appreciated.

 

[Erel]

Which Android device are you using? Are you sure that it supports BLE?

Are you running this example: https://www.b4x.com/android/forum/threads/rcurieble-arduino-101-ble.70704/ ?

Can you post the B4A logs?

 

[Beja]

Hi Erel,
No logs in Android side.. when run it says "Trying to connect"

The B4R app also compiles fine, and the log is "Sending 'open' command to B4J serial connector."

I hope it's not from my phones.. I am using LG G Stylo, and Samsung DUOS

 

[Beja]

Just used "BLE Checker" from Donly Tools.. both mobiles support BLE

 

[Cableguy]

Just used "BLE Checker" from Donly Tools.. both mobiles support BLE

Hummm maybe a too obvious question but, what board are you running it on?
Arduino 101 is a "special" version of the Uno with built in Bluetooth...

 

[Beja]

Hummm maybe a too obvious question but, what board are you running it on?
Arduino 101 is a "special" version of the Uno with built in Bluetooth...

Yes exactly.. And that's why I am using it..
Check this.
https://www.b4x.com/android/forum/threads/rcurieble-arduino-101-ble.70704/

 

[Cableguy]

I saw your posts a few minutes after I posted the previous, so I meant no disrespect to you @Beja, only to mention that sometimes we bypass the obvious...

 

[Beja]

I never thought like that.. I just replied to you briefly because was going out and was late.. that I even forgot to tell you Thanks for the reply. Thank you

 

[Erel]

No logs in Android side.. when run it says "Trying to connect"

Are you using B4A-Bridge? The logs will only appear in debug mode.