iOS Question B4I app will not start reliably in debug mode

[touchsquid]

When debugging an existing, large and complex app, the spp compiles without errors and the install dialog comes up on B4i bridge. However, the app never starts. If I manually trys to start the app, the "waiting for IDE to connect" message comes up and stays up.

Sometimes, after deleting the app from the device and cleaning the project, the app will start.

Any ideas to avoid this, since deleting the app loses all stored information.

 

[Erel]

Are you using B4i v10?

 

[touchsquid]

Yes. All latest updates applied.

 

[touchsquid]

I am not sure what happened. I changed a few lines of code and it started working. I think it was crashing with an error before the debugger connected.