B4R Question dont run log() command

vali khandangoll · Jul 2, 2019

Hi all of you.
I have a very simple problem.
I use log("hello") command in my B4R project but do not show any text when run that.

thanks.

Erel · Jul 3, 2019

You need to provide more information.
Device? Bandwidth? What do you see in the logs?

rbghongade · Jul 3, 2019

Check the baud rates at both the microcontroller and PC logger ends. They should be same.

vali khandangoll · Jul 6, 2019

Erel said:
You need to provide more information.
Device? Bandwidth? What do you see in the logs?

vali khandangoll · Jul 6, 2019

rbghongade said:
Check the baud rates at both the microcontroller and PC logger ends. They should be same.

Erel · Jul 7, 2019

Are you able to see the logs with Arduino IDE?

Erel · Jul 7, 2019

Another thing, try to reset the board after the program runs. I have a device that only starts logging after a reset.

vali khandangoll · Jul 13, 2019

Erel said:
Another thing, try to reset the board after the program runs. I have a device that only starts logging after a reset.

hi.
I reset arduino board and didnot currect.
this problem evented when I installed new version of B4R.

i think this problen never be solve. I must use LCD for view log.
thanks.

B4R Question dont run log() command

vali khandangoll

Active Member

Erel

B4X founder

rbghongade

Active Member

vali khandangoll

Active Member

Attachments

vali khandangoll

Active Member

Attachments

Erel

B4X founder

Erel

B4X founder

vali khandangoll

Active Member

Similar Threads

B4R Question dont run log() command

Active Member

B4X founder

Active Member

Active Member

Attachments

Active Member

Attachments

B4X founder

B4X founder

Active Member

Similar Threads

Privacy & Transparency

Privacy & Transparency